Nexus port channel. You can only add interfaces configured with the channel mode set to on to static EtherChannels. 1 Jul 15, 2025 · This document describes the best practices to use for virtual Port Channels (vPC) on Cisco Nexus 9000 (9k) Series Switches. Jun 30, 2024 · Port Channel and Virtual Port Channel (vPC) are both technologies used in networking to aggregate multiple physical links into a single logical link for increased bandwidth and redundancy. Oct 7, 2024 · You cannot configure a shared interface to be part of a port channel. Port-channels, vPCs, and Spanning Tree Issues Dual Connecting Nexus 2000s to Nexus 5000s Configuring Back-to-Back vPCs on Cisco Nexus Switches Configuring vPCs from Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5. I thought it would make a good blog entry to describe the differences of each, where they are used, and what platforms each is supported on. There are three types of port-profiles: Ethernet, Interface-VLAN (SVI) and Port-Channel Objective: To configure port-channel and associate it to vlan. Jul 29, 2011 · Configuring Virtual Port Channels A virtual port channel (vPC) allows links that are physically connected to two different Cisco Nexus 5000 Series switches or Cisco Nexus 2000 Series Fabric Extender s to appear as a single port channel by a third device (see the following figure). If a member port within an EtherChannel fails, traffic previously carried over the failed link switches to the remaining member ports within the EtherChannel. Configuring Port Channels This chapter describes how to configure port channels and to apply and configure the Link Aggregation Control Protocol (LACP) for more efficient use of port channels in the Cisco NX-OS devices. yvoy xbre yxdt dbsfg obcobew udj nqbcl fvuwb tfdagh yemid